Is BotInfo supported by default?

[[PT]Devilishly]

Hi!

I'm developing an hublist and I want to have suport for BotInfo.. I've seen its syntax in http://www.dcpp.net/wiki/index.php/%24BotINFO, and I've tryed to used it in an Ptokax hub, but nothing happens..
I've done the authentication as a normal user, and then send the BotInfo command..

Well is this command supported by default in ptokax(and if so, how is the protocol for using it), and if not, which script do i've to use?

Thanks!

[Carraya]

Well there is your problem...

You should not login normally if you want to use Botinfo...

If I remember correctly it should be sent in supports and then again after validate nick, but I might not be right about that. Anyways remember to send it in supports.

[Todi]

You should send the $BotINFO in your $Supports, some hubs might not want to send you $HubINFO unless you've done this. But i don't think you have to do any special logins like Carraya says. I suggest you try it on other hubsofts too, like YnHub, so it's not just a buggy hubsofts fault.

[[PT]Devilishly]

Thanks for your help
Ok, now I can send BotINFO and also handle the HubInfo from hub. I'm using the following string:

Code: Select all

"$Supports BotINFO|$Key "+key+"|$BotINFO "+description+"|"

Now, another question What can I do, when in BotINFO "mode"? I'm asking this, cause I've also tried to send the ValidateNick command and GetNickList command and the hub answered correctly..
Is there any site where I can check the complete protocol for an HubList pinger??

I've checked the wiki, but I've only found this http://www.dcpp.net/wiki/index.php/Hublist_Pinger ..